Figure 16. Removing I/O Card From Riser 1
1
I/O card 2 Latch
3 Thumbscrew 4 Retainer
Install an I/O Card in Riser 1
Use this procedure to install an I/O card in riser 1.
Steps
1 Unpack the replacement I/O card, and prepare it for installation. For instructions, see the documentation accompanying the I/O card.
2 Holding the I/O card by its edges, position the card so that the card‐edge connector aligns with the I/O card connector on the riser.
Figure 17. I/O Card Connector Location on Riser 1
1
Card connector
28 Replacing Storage System Components
To Next Page
Loading...
