About this guide
This guide provides site preparation recommendations, step-by-step procedures for installing your device, and connecting to a power
source.
CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling this equipment.
NOTE: Only trained and qualified personnel can install this equipment. Read this guide before you install and power up
this equipment. This equipment contains two power cables. Disconnect both power cables before servicing.
NOTE: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation.
Figure 1. Class 1 laser product tag
NOTE: When no cable is connected, visible and invisible laser radiation may emit from the aperture of the optical
transceiver ports. Avoid exposure to laser radiation. Do not stare into open apertures.
NOTE: Read this guide before unpacking the device. For unpacking instructions, see Unpack.
Regulatory
Marketing model Dell EMC SD-WAN Edge 600 Series (610, 620, 640, and 680) are represented by the regulatory model E24W and the
regulatory type E24W001.
Topics:
• Related documents
• Information symbols
Related documents
For more information about the Dell EMC SD-WAN Edge 600 Series, see the following documents:
• Dell EMC SD-WAN Edge 600 Series Quick Start Guide
• Dell EMC SD-WAN Edge 600 Series Release Notes
NOTE:
For the most recent documentation, see the Dell EMC support site at www.dell.com/support.
Information symbols
This book uses the following information symbols:
NOTE:
The Note icon signals important operational information.
CAUTION: The Caution icon signals information about situations that could result in equipment damage or loss of data.
NOTE: The Warning icon signals information about hardware handling that could result in injury.
1
About this guide 5
To Next Page
Loading...
Need help?
General
