Need help?Do you have a question about the Dell EMC Unity 400 and is the answer not in the manual?
General| Model | Dell EMC Unity 400 |
|---|---|
| Category | Storage |
| Form Factor | 2U |
| RAID Levels Supported | RAID 5, RAID 6, RAID 10 |
| Warranty | 3 years |
| Drive Types Supported | SAS, NL-SAS, SSD |
| Supported Protocols | iSCSI, NFS |
| Maximum Host Connectivity | 16 |
| Processor | Dual Intel Xeon |
| Operating System | Dell EMC Unity Operating Environment |
| Power Supply | Redundant power supplies |
| Management Interface | Unisphere |
Details the necessary tools, management console, and physical space requirements for installation.
Provides procedures and requirements to prevent damage from electrostatic discharge during installation.
Guides on mounting the main storage system into the rack.
Instructions on how to secure the Disk Processor Enclosure onto the installed rails.
Procedures for powering on the Disk Processor Enclosure.
How to interpret status LEDs on the storage processor and DPE after power-up.
Steps for automatically configuring the management IP address via DHCP.
Steps for manually configuring the management IP address using the Connection Utility.
To Next Page