Dell EMC Unity 500 - User Manual

Dell EMC Unity
™
Family
Unity 300/300F, Unity 350F, Unity
380/380F, Unity 400/400F, Unity 450F,
Unity 500/500F, Unity 600/600F and
Unity 650F
Installation Guide
P/N 302-002-562
REV 05

Dell EMC Unity 500 Specifications

General

Brand	Dell EMC
Model	Unity 500
Category	Storage
Language	English

Summary

Prepare your system

Before you begin

Prepare for system setup by reviewing prerequisites and account requirements.

Site and equipment preparation

Details the necessary tools, space, and network connections for installation.

Avoiding electrostatic discharge (ESD) damage

Provides procedures to prevent damage to electronic components from static electricity.

Install your storage system components into a rack

Install the disk processor enclosure

Installing the DPE on the rails

Cable and power up your storage system components

Attach the storage processors to the network

Connects the storage processors (SPs) to the network for configuration and management.

DPE power up

Details the steps for powering on the Disk Processor Enclosure (DPE).

Verify status LEDs

Set up a management interface connection

Connect a Windows-based computer to your storage system

How to establish a connection from a PC for system setup.

Automatically assigning a dynamic storage system management port IP address

Manually assigning a static storage system management port IP address

Install your DAE components into a rack

Install the disk array enclosure

Cable and power up your DAE components

Cabling the DPE to a DAE

Explains how to connect the Disk Processor Enclosure (DPE) to Disk Array Enclosures (DAEs).

Cabling an expansion DAE to an existing DAE to extend a back-end bus

Connecting power to the DAE