Dell 2400 - Installing the Slide Assemblies in the Rack; Figure 1-5. Removing the 24-U Rack Doors

support.dell.com Dell PowerEdge 2400 Systems Rack Installation Guide 1-7
Figure 1-5. Removing the 24-U Rack Doors
Installing the Slide Assemblies in the Rack
NOTE: If the slide assemblies were preinstalled by Dell, you may skip this section.
You must allow 6 U (10.5 inches) of vertical space for each PowerEdge 2400 system
you install in the rack.
NOTE: The rails of the rack are marked by small indentations in 1-U increments (see
Figure 1-6).
hinge insert
hinge pin
hinge