Dell 2400 - Figure 1-13. Installing the Computer in the Rack

support.dell.com Dell PowerEdge 2400 Systems Rack Installation Guide 1-15
3. Tilt the computer while aligning the back shoulder screws on the top and the
bottom of the computer with the back rail slots on the slide assemblies.
WARNING: Make sure that the server shoulder screws are securely
engaged in the slots.
4. Engage the back shoulder screws in the slot behind the back (green) latch first
followed by the middle shoulder screw in the slot near the middle (yellow) latch.
Finally, engage the front shoulder screw in the front slot.
5. Push the chassis inward until the middle (yellow) latch is engaged (see
Figure 1-13).
Figure 1-13. Installing the Computer in the Rack
back latch
(green)
middle
latch (yellow)