Feature
3. Battery status LED Indicates the power‑state of the attached
battery.
4. 19.5 VDC power adapter port Connect a +19.5 VDC power adapter to
provide power to your Gateway.
5. 24V AC/DC power port Connect a +24V AC/DC power source to
power your Gateway.
6. Sealed lead-acid battery port Connect an external battery back to the
power module to provide back-up power
in case of power interruption.
7. Bottom release-latch Push both the top and bottom release-
latch to disconnect the power module
from the Dell Edge Gateway.
8. Dell Edge Gateway expansion
port
Connect the power module to the Dell
Edge Gateway for increased power
options and to power the I/O expansion
module.
Setting up the Power Module
WARNING
: Before installng the Power Module shutdown the Dell Edge
Gateway and disconnect the power cable.
NOTE: The power module is required to be connected with the Dell Edge
Gateway to enable and use the I/O expansion module.
1 Remove the dust-cap covering the Power Module expansion port on the Dell
Gateway connector.
Power Module Overview 43
To Next Page
Loading...
