You can use the following printer control buttons:
l Refresh: renews the available printers list.
l Add Printer: allows you to add a new printer.
l Remove Printer: removes the selected printer.
l Set as Default: sets the current printer as a default printer.
l Stop/Start: stops/starts the printer.
l Test: allows you to print a test page to check if the machine is working properly.
l Properties: allows you to view and change the printer properties. For details, see "Configuring Printer Properties".
Classes Tab
The Classes tab shows a list of available printer classes.
l Refresh: renews the classes list.
l Add Class...: allows you to add a new printer class.
l Remove Class: removes the selected printer class.
Ports Configuration
In this window, you can view the list of available MFP ports, check the status of each port, and release a port that is stalled in a busy state after its owner has
To Next Page
Loading...
