Installing touchpad
1 Place the touchpad into the slots on the computer.
2 Place the metal bracket, and ax the adhesive tape.
3 Replace the screws (M2.0x3.0, M.2.0x2.0) that secure the metal bracket on the computer.
NOTE
: Ax the adhesive tape that secures the speaker cable on the metal bracket.
4 Connect the touchpad cable.
5 Ax the adhesive tape to secure the speaker cable on the computer.
6 Connect the speaker cable to the connector on the system board.
7 Install the:
a speaker
b battery
c base cover
d microSD card
8 Follow the procedure in After working inside your computer.
System board
Removing system board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
18
Removing and installing components
To Next Page
Loading...
