NOTE: The display back-cover and antenna assembly cannot be further disassembled once all the pre-removal parts
procedures are completed. The picture and table below shows the display back-cover and antenna assembly after
performing the pre-removal parts procedures for any display back-cover and antenna assembly replacement.
a Display cable
b LED Daughter board
c Camera module
d Wireless Antennas (Main+Aux)
e Right Display Hinge
f Left Display Hinge
Installing display back cover
1 Align the display back cover with the tabs on the computer, and press it until it clicks into place.
2 Follow the procedure in After working inside your computer.
Installing camera
1 Place the camera on the display assembly.
2 Connect the camera cable to the connector on the display assembly.
3 Install the:
a display panel
b display bezel
c display assembly
d battery
e base cover
f microSD card
30
Removing and installing components
To Next Page
Loading...
