Steps
1. Align and slide the 3.5-inch hard drive into the hard-drive cage.
2. Replace the two (#6-32) screws to secure the 3.5-inch hard drive to the hard-drive cage.
3. Align and slide the hard drive assembly into the hard-drive and optical-drive bracket.
4. Replace the two (#6-32) screws to secure the 3.5-inch hard drive assembly to the hard-drive and optical-drive bracket.
5. Connect the power cable and data cable to connectors on the 3.5-inch hard drive.
Next steps
1. Install the front cover.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
16
Removing and installing components
To Next Page
Loading...
