Steps
1. Align and slide the tabs on the power supply unit into the latches on the chassis.
2. Align the screw holes on the power supply unit with the screw holes on the chassis.
3. In a sequential order (1>2>3), replace the three screws (#6-32) to secure the power supply unit on the chassis.
4. Route the power supply unit cables through the routing guides on the chassis.
5. Connect the system-board power cable and the processor-power cable to the connectors on the system board.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Install the 3.5-inch hard drive or 2.5-inch hard drive.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Antenna modules
Removing the antenna modules
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
Removing and installing components
37
To Next Page
Loading...
