Steps
1. Align the screw hole on the media-card reader bracket with the screw holes on the system board and the chassis.
2. Align and slide the media-card reader and the bracket into the slot on the system board.
3. Replace the two screws (M3x5) to secure the media-card reader bracket on the system board and the chassis.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Install the 3.5-inch hard drive or 2.5-inch hard drive.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Power supply unit
Removing the power supply unit
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the 3.5-inch hard drive or 2.5-inch hard drive.
5. Remove the hard-drive and optical-drive cage.
About this task
The following images indicate the location of the power supply unit and provide a visual representation of the removal
procedure.
34
Removing and installing components
To Next Page
Loading...
