Steps
1. Gently align and place the processor fan and heat-sink assembly on the processor.
2. Align the screw holes on the processor fan and heat-sink assembly with the screw holes on the system board.
3. In a sequential order (1>2>3>4), tighten the four captive screws to secure the processor fan and heat-sink assembly on the
system board.
4. Connect the fan and heat-sink assembly cable to the connector on the system board.
Next steps
1. Install the fan shroud.
2. Install the left-side cover.
3. Follow the procedure in After working inside your computer.
Processor
Removing the processor
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the fan shroud.
4. Remove the fan and heat-sink assembly.
About this task
The following image indicates the location of the processor and provides a visual representation of the removal procedure.
Removing and installing components
43
To Next Page
Loading...
