Steps
1. Slide the power-button cable through the slot on the front of the chassis.
2. Press the tabs on the power button and insert the power button through the slot on the front of the chassis until the power
button is secure in place.
3. Connect the power-button cable to the connector on the system board.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Remove the 3.5-inch hard drive or 2.5-inch hard drive.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Memory
Removing the memory
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the 3.5-inch hard drive or 2.5-inch hard drive.
5. Remove the hard-drive and optical-drive cage.
About this task
The following image indicates the location of the memory and provides a visual representation of the removal procedure.
Removing and installing components
23
To Next Page
Loading...
