Steps
1. Align the optical drive bezel to the optical drive and snap the bezel onto the optical drive.
NOTE: Start from the edge of the bezel with the smaller securing tabs and snap them into place.
2. Slide the optical drive into the hard-drive and optical-drive bracket.
3. Replace the (M2x3) screw to secure the optical drive to the hard-drive and optical-drive bracket.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Install the 3.5-inch hard drive or 2.5-inch hard drive.
3. Install the front cover.
4. Install the left-side cover.
5. Follow the procedure in After working inside your computer.
Removing and installing components
21
To Next Page
Loading...
