About this task
NOTE: If you are replacing a M.2 2230 solid-state drive with a M.2 2280 solid-state drive, ensure the M.2 2230 solid-state
drive is removed first.
NOTE: See the procedure for removing the M.2 2230 solid-state drive.
NOTE: The following image indicates the location to install the solid-state drive screw mount based on form factor.
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 card slot.
2. Slide the M.2 2280 solid-state drive at an angle into the M.2 card slot on the system board.
3. Replace the screw (M2x3) to secure the M.2 2280 solid-state drive to the system board.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Install the 3.5-inch hard drive or 2.5-inch hard drive.
3. Install the front cover.
28
Removing and installing components
To Next Page
Loading...
