43
|
Possible Solutions
Screen image is too
small
Check the Aspect Ratio setting in the Display settings OSD.
Reset the monitor to Factory Settings (Factory Reset).
Cannot adjust the
monitor with the
buttons on the bottom
of the panel
Turn o the monitor, unplug the power cord, plug it back, and then
turn on
the monitor.
No input signal when
user controls are
pressed
Check the signal source. Ensure the computer is not in standby
or sleep mode by moving the mouse or pressing any key on the
keyboard.
Check if the video cable is plugged in properly. Disconnect and
reconnect the video cable if necessary.
Reset the computer or video player.
The picture does not
ll the entire screen
Due to dierent video formats (aspect ratio) of DVDs, the monitor may
display in full screen.
Run the built-in diagnostics.
Troubleshooting
To Next Page
Loading...
