50 Adding Parts
www.dell.com | support.dell.com
7 Replace the computer cover (see page 71).
NOTICE: To connect a network cable, first plug the cable in to the network
jack and then plug it in to the computer.
8
Plug your computer and devices into their electrical outlets, and turn
them on.
Adding a Second Hard Drive
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
Your computer includes one hard drive. To add a second hard drive, perform
the following steps.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network jack.
1
Turn off the computer and devices, and disconnect them from their
electrical outlets.
2 Briefly press the power button.
Pressing the power button when the computer is not connected to an
electrical outlet discharges residual electricity and can help prevent
system board damage.
3 Remove the computer cover (see page 42).
To Next Page
Loading...
