Adding Parts 45
Adding Cards
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
Install only PCI cards in your computer. Before installing a card, make sure
that a slot is available for it.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network jack.
1
Turn off the computer and devices, and disconnect them from their
electrical outlets.
2 Briefly press the power button.
Pressing the power button when the computer is not connected to an
electrical outlet discharges residual electricity and can help prevent
system board damage.
3 Remove the computer cover (see page 42).
4 Unscrew and remove the filler bracket for the card slot you want to use.
filler bracket
To Next Page
Loading...
