40 Solving Problems
www.dell.com | support.dell.com
Microsoft
®
Windows
®
Error Messages
x
:\ IS NOT ACCESSIBLE. THE DEVICE IS NOT READY — Insert a disk
into the drive and try again.
A FILENAME CANNOT CONTAIN ANY OF THE FOLLOWING
CHARACTERS: \ / : * ? “ < > | — Do not use these characters in
filenames.
NOT ENOUGH MEMORY OR RESOURCES. CLOSE SOME PROGRAMS AND
TRY AGAIN — You have too many programs open. Close all windows and open
the program that you want to use. In some cases, you might have to restart your
computer to restore computer resources. If so, try running the program that you
want to use first.
THE FILE BEING COPIED IS TOO LARGE FOR THE DESTINATION
DRIVE — The file that you are trying to copy is too large to fit on the disk. Try
copying the file to a blank disk or use a larger-capacity disk.
A REQUIRED .DLL FILE WAS NOT FOUND — The program that you are
trying to open is missing an essential file. To remove and then reinstall the
program:
Windows XP
1 Click the Start button.
2 Click Control Panel.
3 Click Add or Remove Programs.
4 Select the program you want to remove.
5 Click the Change or Remove Program icon.
6 See the program documentation for installation instructions.
Windows Me and Windows 2000
1 Click the Start button, point to Settings, and then click Control Panel.
2 Double-click the Add/Remove Programs icon.
3 Select the program that you want to remove.
4 Click Add/Remove (click Change/Remove in Windows 2000) and follow the
prompts on the screen.
5 See the program documentation for installation instructions.
9p915bk0.book Page 40 Thursday, April 4, 2002 9:26 AM
To Next Page
Loading...
