EasyManua.ls Logo

Dell Dimension 8200 - Reattaching the Hinge Arms

Dell Dimension 8200
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Adding Parts 65
Reattaching the Hinge Arms
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside Your
Computer" on page 12.
1
Shut down the computer (see page 20).
2 Disconnect the power cable from your computer.
3 Remove the front door, if it is attached.
The front door snaps off of the two hinge arms.
4 Remove the front-panel insert above the front-door bay area.
Pull the bottom of the insert with your fingers to remove it.
5 Lift both hinge arms to the horizontal position.
front-panel
insert
use fingers
to pull here
9p915bk0.book Page 65 Thursday, April 4, 2002 9:26 AM

Table of Contents

Related product manuals