90 Adding Parts
www.dell.com | support.dell.com
9 Align the notch on the bottom of the module with the crossbar in the connector.
NOTICE: To avoid breaking the memory module, do not press near the middle of the module.
10
Insert the module straight down into the connector, ensuring that it fits into the
vertical guides at each end of the connector. Press firmly on the ends of the module
until it snaps into place.
If you insert the module correctly, the securing clips snap into the cutouts at each end
of the module.
11 Replace the computer cover (see page 100).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
12
Connect your computer and devices to electrical outlets, and then turn them on.
notch
memory module
cutouts (2)
crossbar
To Next Page
Loading...
Need help?
General