92 Adding Parts
www.dell.com | support.dell.com
3 Pull the card up and out of the card clip.
Installing an AGP Card
1 To add or replace the card, press the card lever toward the PCI connector and gently
press the card into the AGP connector until it clicks into place.
2 Release the card lever, ensuring that the tab fits into the notch on the front end of
the card.
3 Secure the card by lowering the hinged lever on the back panel.
4 Close the computer cover (see page 100).
tab
card clip
lever
notch
PCI connector
AGP connector
back of computer
card clip
lever
AGP card
card clip
slot connector
To Next Page
Loading...
