Dell E1910H - Setting up the Monitor; Attaching the Stand; Connecting Your Monitor; Connecting the Blue Vga Cable

Back to Contents Page

Setting Up the Monitor
Dell™E1910H Flat Panel Monitor User's Guide
Attaching the Stand
Connecting Your Monitor
Removing the Stand Base 
Attaching the Dell Soundbar (Optional)
Removing the Stand for VESA wall mount

Attaching the Stand


Connecting Your Monitor
To connect your monitor to the computer:
1. Turnoffyourcomputeranddisconnectthepowercable.
2. Connectthebluedisplayconnectorcabletothecorrespondingvideoportonthebackofyourcomputer.
Connecting the Blue VGA Cable
NOTE: The stand is detached when the monitor is shipped from the factory.
To attach the base of the stand to the monitor stand:

1.
Place the monitor stand base on a stable table top.
2.
Slide the monitor stand body in the correct direction down onto the back until it clicks into place.
CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions.