Dell EMC AX4-5 - AX4-5 F SAN-Attached Cabling Guide

Cabling Your Cluster Hardware 27
Cabling a SAN-Attached Cluster to an AX4-5F Storage System
1 Connect cluster node 1 to the SAN.
a Connect a cable from HBA port 0 to Fibre Channel switch 0 (sw0).
b Connect a cable from HBA port 1 to Fibre Channel switch 1 (sw1).
2 Repeat step 1 for each cluster node.
3 Connect the storage system to the SAN.
a Connect a cable from Fibre Channel switch 0 (sw0) to SP-A Fibre
port 0(first fibre port
).
b Connect a cable from Fibre Channel switch 0 (sw0) to SP-B Fibre
port 1(second fibre port
).
c Connect a cable from Fibre Channel switch 1 (sw1) to SP-A Fibre
port 1(second fibre port
).
d Connect a cable from Fibre Channel switch 1 (sw1) to SP-B Fibre
port 0(first fibre port
).