2. Follow the procedure listed in Before working inside your system.
3. Remove the air shroud.
4. Remove the PSU or PSU blank.
5. Disconnect the cables that are connected to power interposer board (PIB).
Steps
1. Pull the plunger up and move back to release hook.
2. Lift the PIB away from the system.
Figure 71. Removing the power interposer board
Next steps
Replace the power interposer board.
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Align the PIB board on the chassis with the edge of the hook.
2. Press the board and move it forward to hook it.
76
Installing and removing system components
To Next Page
Loading...
