Installation and Setup Installing a PS6000 Array
2–12
Attach the cable to the serial port on the active control module (ACT LED will be
green) and to a console terminal or a computer running a terminal emulator. See
Figure 2-8 (not to scale).
Figure 2-8: Connecting a Serial Cable to the Array
System Ground 5 5 System Ground
Data Set Ready + Carrier Detect 6+1 4 Data Terminal Ready
Request to Send 7 8 Clear to Send
Clear to Send 8 7 Request to Send
Table 2-5: DB9 to DB9 Pinout Information (Continued)
DB9-1 DB9-2
Function Pin Pin Function
To Next Page
Loading...
