Dell EqualLogic PS Series - MicroSD Card Management

Installation and Setup Installing a PS6500 Array
2–21
cables have sufficient slack between the array back panel and the first
connection to the cable management system ( ).
Figure 2-14: Cable Routing Diagram
2. Connect all three fasteners on the arm and place the cables below the arms.
See Figure 2-15.
Figure 2-15: Attaching the Hook-and-Loop Fasteners
3. Route the cables along the middle arm of the three-arm assembly, going from
to in Figure 2-14.
4. Route the cables along the one-arm assembly (connected to the top of the left
and right rails), going from to in Figure 2-14.
After routing the cables, the installation should resemble Figure 2-16.