Steps
1. Note the routing of the cable that connects the left speaker to the right speaker and remove it from the routing guides on
the palm-rest and keyboard assembly.
NOTE: Note the position of the rubber grommets before lifting the speakers.
2. Peel the tape that adheres the speaker cable to the palm-rest and keyboard assembly.
NOTE:
Note the routing of the speaker of cable and remove it from under the I/O board before disconnecting the cable
from the system board.
3. Disconnect the speaker cable from the system board and release the cable from below the I/O board board .
4. Lift the speakers, along with the cable, off the palm-rest and keyboard assembly.
Installing the speakers
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
28
Removing and installing components
To Next Page
Loading...
