Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly
NOTE:
If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
2. Connect the speaker cable to the system board and route the cable below the I/O board board .
3. Adhere the speaker cable to the palm-rest and keyboard assembly.
4. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE: Route the speaker cable below the I/O board. Do not route the speaker cable over the solid-state drive bracket.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Front-panel light-board
Removing the front-panel light-board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the speakers.
About this task
The following images indicate the location of the front-panel light-board and provide a visual representation of the removal
procedure.
Removing and installing components
29
To Next Page
Loading...
