Steps
1. Open the latch and disconnect the front-panel light-cable from the front-panel light-board.
2. Release the front-panel light-board from the antenna cables on the palm-rest and keyboard assembly.
3. Peel the front-panel light-board from the palm-rest and keyboard assembly.
4. Lift the front-panel light-board off the palm-rest and keyboard assembly.
Installing the front-panel light-board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front-panel light-board and provide a visual representation of the installation
procedure.
30
Removing and installing components
To Next Page
Loading...
