Steps
1. Align and place the front-panel light-board below the antenna cables on the palm-rest and keyboard assembly.
2. Adhere the front-panel light-board in slot on the palm-rest and keyboard assembly.
3. Open the latch and connect the front-panel light-cable to the front-panel light-board.
Next steps
1. Install the speakers.
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Rear cover
Removing the rear cover
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the rear cover and provides a visual representation of the removal procedure.
Removing and installing components
31
To Next Page
Loading...
