108 Adding and Replacing Parts
www.dell.com | support.dell.com
5 Pull the drive out of the bay.
6 Slide the new drive into the bay until the drive is fully seated.
7 Replace the screw that you removed in step 3.
8 Replace the memory module cover and screw.
Keyboard
1 Complete the instructions in "Before You Add or Replace Parts" on
page 100.
2 Use a small flat-blade screwdriver or plastic scribe to lift the notched
right edge of the hinge cover, and pry the cover loose from the hinges
and bottom case.
3 Lift the hinge cover up and away from the hinges and bottom case.
4 Remove the four keyboard screws.
hinge cover
To Next Page
Loading...
