Removing the power-adapter
port
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the battery.
2 Remove the base cover.
3 Remove the optical drive.
4 Remove the memory modules.
5 Follow the procedure from step 1 to step 3 in “Removing the hard drive”.
6 Remove the wireless card.
7 Remove the keyboard.
8 Remove the computer base.
9 Remove the heat-sink assembly.
10 Remove the I/O board.
11 Remove the system board.
Procedure
1 Note the power-adapter-port cable routing and remove the cable from
its routing guides on the palm-rest assembly.
2 Remove the screw that secures the power-adapter port to the palm-rest
assembly.
63
To Next Page
Loading...
