Replacing the display back-
cover and antenna assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
Place the display back-cover and antenna assembly on a clean, flat surface.
Post-requisites
1 Replace the display cable.
2 Replace the display hinges.
3 Replace the display panel.
4 Replace the camera.
5 Replace the display bezel.
6 Replace the display assembly.
7 Replace the system board.
8 Replace the I/O board.
9 Replace the heat-sink assembly.
10 Replace the computer base.
11 Replace the keyboard.
12 Replace the wireless card.
13 Follow the procedure from step 5 to step 7 in “Replacing the hard drive”.
14 Replace the memory modules.
15 Replace the optical drive.
16 Replace the base cover.
17 Replace the battery.
98
To Next Page
Loading...
