Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Place the palm rest at the edge of the table with the speakers facing away
from the edge.
2 Align the screw holes on the palm-rest assembly with the screw holes on
the display hinges.
3 Replace the screws that secure the display hinges to the palm-rest
assembly.
4 Route the antenna cables through its routing guides on the palm-rest
assembly.
5 Route the display cable through its routing guides on the palm-rest
assembly.
Post-requisites
1 Replace the system board.
2 Replace the I/O board.
3 Replace the heat-sink assembly.
4 Replace the computer base.
5 Replace the keyboard.
6 Replace the wireless card.
7 Follow the procedure from step 5 to step 7 in “Replacing the hard drive”.
8 Replace the memory modules.
9 Replace the optical drive.
10 Replace the base cover.
11 Replace the battery.
76
To Next Page
Loading...
