Installing the power button
Prerequisites
CAUTION: The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the power button and provides a visual representation of the installation
procedure.
Steps
1. Place the power button on the palm-rest and keyboard assembly.
2. Place the power-button board on the power button.
3. Align the screw holes on the power-button board with the screw holes on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x3) to secure the power-button board to the palm-rest and keyboard assembly.
5. Connect the power-button board cable to I/O board and close the latch.
6. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and
keyboard assembly.
7. Replace the two screws (M2.5x5) to secure the left display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
60
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
