Power-adapter port
Removing the power-adapter port
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the system board.
NOTE: The system board can be removed and installed with the M.2 solid-state drive, memory module, and heat sink
attached.
About this task
The following image(s) indicate the location of the power-adapter port and provides a visual representation of the removal
procedure.
Steps
1. Remove the two screws (M2.5x5.5) that secure the right display-assembly hinge to the system board.
2. Open the right display-assembly hinge at an angle of 90 degrees.
3. Lift the power-adapter port and its cable off the palm-rest and keyboard assembly.
Installing the power-adapter port
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
78
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
