150 Removing and Installing Parts
NOTICE: Be careful not to bend any of the pins when you remove the processor.
Bending the pins can permanently damage the processor.
8
Remove the processor from the socket.
Leave the release lever extended in the release position so that the socket is
ready for the new processor.
NOTICE: After removing the processor, be careful not to get any thermal grease
on the processor pins. Thermal grease on the pins can permanently damage
the processor.
Installing the Processor
NOTICE: Ground yourself by touching an unpainted metal surface on the back of
the computer.
1
Follow the procedures in "Before You Begin" on page 101.
NOTICE: Be careful not to bend any of the pins when you unpack the processor.
Bending the pins can permanently damage the processor.
2
Unpack the new processor, being careful not to bend any of the processor pins.
1 processor 2 release lever 3 socket
2
3
1
book.book Page 150 Wednesday, April 16, 2008 3:33 PM
To Next Page
Loading...
