Removing and Installing Parts 165
Replacing the Computer Cover
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1
Ensure that all cables are connected, and fold cables out of the way.
2
Ensure that no tools or extra parts are left inside the computer.
3
Align the tabs at the bottom of the computer cover with the slots located
along the edge of the computer.
4
Press the computer cover down and slide it towards the front of the
computer until you feel a click or feel the computer cover securely
installed.
5
Ensure that the cover is seated correctly.
6
Replace and tighten the two screws that secure the computer cover, using a
flat-blade screwdriver.
1 support bracket 2 card retention bracket 3 card retention release lever
1
2
3
book.book Page 165 Wednesday, April 16, 2008 3:33 PM
To Next Page
Loading...
