Mini-Card 41
Replacing the Mini-Card
CAUTION: The connectors are keyed to ensure correct insertion. Use of
excessive force may damage the connectors.
CAUTION: To avoid damage to the Mini-Card, ensure that there are no cables
under the Mini-Card.
Procedure
1
Align the notch on the Mini-Card with the tab on the
system-board connector.
2
Insert the Mini-Card at a 45-degree angle into the system-board connector.
3
Press the other end of the Mini-Card down into the slot on the
system board and replace the screw that secures the Mini-Card to the
system board.
4
Connect the appropriate antenna cables to the Mini-Card you are
installing. The Mini-Card has two triangles marked on the label
(black and white):
• Connect the black cable to the connector marked with a
black triangle.
• Connect the white cable to the connector marked with a
white triangle.
Postrequisites
1
Replace the computer cover. See "Replacing the Computer Cover" on
page 19.
2
Follow the instructions in "After Working Inside Your Computer" on
page 11.
book.book Page 41 Tuesday, April 17, 2012 11:37 AM
To Next Page
Loading...
