Dell Inspiron 660 - Replacing the Processor

Processor 75
Replacing the Processor
Procedure
1 Unpack the new processor, being careful not to touch the underside of
the processor.
CAUTION: You must position the processor correctly in the processor socket to
avoid damage to the processor.
2 If the release lever on the socket is not fully extended, move it to that
position.
3 Orient the alignment notches on the processor with the alignment tabs on
the socket.
4 Align the pin-1 corner of the processor with the pin-1 corner of the
processor socket, and then place the processor in the processor socket.
Set the processor lightly in the socket and ensure that the processor is
positioned correctly.
1 socket 2 processor 3 alignment tabs (2)
4 alignment notches (2) 5 processor pin-1 indicator
1
3
5
4
2
book.book Page 75 Tuesday, April 17, 2012 11:37 AM