Power Button Module 63
Replacing the Power Button Module
Procedure
1
Align and push the power button module tabs into the slots on the front
panel.
2
Connect the power button module cable to the system board connector
(LEDH2). See "System Board Components" on page 14.
Postrequisites
1
Replace the front bezel. See "Replacing the Front Bezel" on page 27.
2
Replace the computer cover. See "Replacing the Computer Cover" on
page 19.
3
Follow the instructions in "After Working Inside Your Computer" on
page 11.
book.book Page 63 Tuesday, April 17, 2012 11:37 AM
To Next Page
Loading...
