22 Memory Module(s)
Procedure
WARNING: The memory module(s) may become very hot during normal operation.
Allow the memory module(s) to cool before touching them.
1
Locate the memory module(s) on the system board. See "System Board
Components" on page 15.
2
Press out the securing clip at each end of the memory-module connector.
3
Grasp the memory module and pull it upward.
If the memory module is difficult to remove, gently ease the memory
module back and forth to remove it from the connector.
1 memory-module connector 2 memory module
3 securing clips (2)
book.book Page 22 Thursday, April 5, 2012 5:38 PM
To Next Page
Loading...
