PCI-Express Cards 27
Replacing the PCI-Express Cards
Procedure
1
Prepare the card for installation.
See the documentation that shipped with the card for information on
configuring the card, making internal connections, or otherwise
customizing it for your computer.
2
Replace the PCI-Express card:
PCI-Express x1 card
— Place the PCI-Express card in the connector on
the system board and press down firmly. Ensure that the PCI-Express card
is fully seated in the connector.
PCI-Express x16 card
— Press down the securing tab and place the PCI-
Express card in the connector on the system board and press down firmly.
Ensure that the PCI-Express card is fully seated in the connector.
3
Connect any cables that should be attached to the card.
See the documentation that shipped with the card for information about
the card’s cable connections.
CAUTION: Do not route card cables over or behind the cards. Cables routed over
the cards can prevent the computer cover from closing properly or cause damage
to the equipment.
Postrequisites
1
Replace the fan shroud. See "Replacing the Fan Shroud" on page 20.
2
Replace the computer cover. See "Replacing the Computer Cover" on
page 18.
3
Follow the instructions in "After Working Inside Your Computer" on
page 11.
4
To complete the installation, see "Configuring Your Computer After
Removing or Installing the PCI-Express Card" on page 28.
book.book Page 27 Thursday, April 5, 2012 5:38 PM
To Next Page
Loading...
