70 System Board
Procedure
NOTE: Your computer’s Service Tag is stored in the system board. You must enter
the Service Tag in the BIOS after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location of
the connectors, so that you can reconnect them correctly after you replace the
system board.
1
Disconnect all the cables from their connectors on the system board.
2
Remove the screws that secure the system board to the chassis.
3
Lift the system board up and out of the chassis.
1 screws (6) 2 system board
book.book Page 70 Thursday, April 5, 2012 5:38 PM
To Next Page
Loading...
