Replacing the Hard Drive
1. Follow the instructions in Before You Begin.
2. Remove the new hard drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
3. Place the hard drive on the computer base.
4. Push the hard drive towards the left to connect it to the connector on the system board.
5. Follow the instructions from step 3 to step 7 in Replacing the Palm-Rest Assembly.
6. Replace the two screws to the computer base.
7. Replace the battery. See Replacing the Battery.
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
