Back to Contents Page
Camera Module
Dell Inspiron M5040/15-N5040/15-N5050 Owner's Manual
Removing the Camera Module
Replacing the Camera Module
Removing the Camera Module
1. Follow the instructions in Before You Begin.
2. Remove the battery. See Removing the Battery.
3. Follow the instructions from step 3 to step 8 in Removing the Palm-Rest Assembly.
4. Remove the hinge cover. See Removing the Hinge Cover.
5. Remove the display assembly. See Removing the Display Assembly.
6. Remove the display bezel. See Removing the Display Bezel.
7. Disconnect the camera cable from the connector on the camera module.
8. Release the two tabs that secure the camera module to the display cover.
9. Lift the camera module from the display cover.
Replacing the Camera Module
1. Follow the instructions in Before You Begin.
2. Connect the camera cable to the connector on the camera module.
3. Use the alignment posts on the display cover to snap the camera module into position.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery, see Removing the Battery, before working inside the computer.
To Next Page
Loading...
