Dell Inspiron M5040 - Display; Display Assembly; Display Bezel

Back to Contents Page
 Display
Dell Inspiron M5040/15-N5040/15-N5050 Owner's Manual
Display Assembly
Display Bezel



Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You Begin.

2. Remove the battery. See Removing the Battery.

3. Remove the two screws from the computer base.

4. Follow the instructions from step 3 to step 8 in Removing the Palm-Rest Assembly.

5. Remove the hinge cover. See Removing the Hinge Cover.

6. Disconnect the display cable from the connector on the system board.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery, see Removing the Battery, before working inside the computer.